NOT covered under warranty!
" Run fog light harness (see Fig. 1)
to fog light in bumper.
STEP 4: POLARIZE FOG LIGHT CONNEC-
TOR
Plug connector from Brite Box's
single brown wire into fog light
harness wire in the following
manner:
FOR ALL 2003 - 2004 TRUCKS:
Plug BROWN single wire from Brite
Box into BROWN wire in fog light
harness.
FOR 2005 TRUCKS WHERE FOG LIGHTS
WERE INSTALLED BY FACTORY:
Plug BROWN single wire from Brite
Box into BROWN wire in fog light
harness.
FOR 2005 TRUCKS WHERE FOG LIGHTS
WERE ADDED USING MOPAR FOG LIGHT
KIT:
Plug BROWN single wire from Brite
Box into BLACK wire in fog light
harness.
STEP 5: Route fog light harness (see
Fig. 1) to fog light on same side of
truck where you installed Brite Box.
Make sure wires do not pass over
any rough / sharp edges that can
wear through the insulation and
cause a short circuit over time. Use
supplied cable ties to secure wires from fog light harness in a neat and tidy manner.
STEP 6: Unplug Dodge's factory harness from fog light bulb and plug it into the female connector from Brite Box's fog light
harness. Note: It is NOT necessary to remove fog light bulb from fog light assembly!
STEP 7: Plug male connector from Brite Box's fog light harness into fog light bulb.
STEP 8: ATTACH POWER LEAD FROM BRITE BOX
Figure Reference: NONE
" Attach ring on Power lead from Brite Box
directly to positive terminal of battery.
" Install 20 Amp fuse into fuse holder.
STEP 9: RUN POWER EXTENSION - SINGLE BATTERY
VEHICLES ONLY!
Figure Reference: NONE
" If your vehicle has TWO batteries, skip this
step entirely.
" This step is required on single battery
vehicles to get power to the Brite Box that you
will be installing behind the passenger side
headlight.
" Follow instructions provided in the power
extension kit. Return to these instructions
when you are finished.
STEP 10: INSTALL NON FOG LIGHT CONTROL BRITE
BOX (NO BROWN WIRE EXITING ENCLOSURE) ON
PASSENGER SIDE HEADLIGHT
Figure Reference: Figures 1-3
" Repeat steps 1 thru 4 to install Brite Box
behind passenger side headlight.
" For single battery vehicles, hook Brite Box's
power lead to power extension.
" For dual battery vehicles, attach ring on
power lead from Brite Box directly to positive
(+) terminal of passenger side battery.
Remove 2 Clips
Remove 3 - 10mm Bolts
Note: Circled bolt on Driver side headlight may
also secure a sensor on some vehicles
FIGURE 2
FIGURE 3
p
Pry area
GENTLY pry headlight forward in circled area
to release pop clip
Pry headlight
this direction
Fender
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais