Beam Shout ts Guia do Utilizador descarregar pdf (Página 14)

SHOUT ts User’s Manual Version 1.0.1

| Home Screen

Immediately after powered up, user must press a bar located on the bottom to

the screen to unlock the SHOUT ts. A delay in displaying time and date is normal

since the unit has to check its internal clock against the GPS receiver. A PIN is

required if the device is setup with password protection. NAL Research ships the

ts without password protection.

Once correct information is entered after powered up, the home screen will

appear. Device status symbols will be shown along the top of the home screen.

Some symbols will not appear until an event is initiated such as sending or

receiving a message.

denotes the Iridium transceiver is off. To preserve battery life the Iridium

transceiver will only turn on when transmitting a message or report.

denotes: (1) the Iridium transceiver is on with real-time signal strength

represented by the number of vertical bars and (2) SBD message transmission is

in progress. The signal strength can range from the lowest of zero to the highest

HOME SCREEN

Status

Symbols

Iridium

GPS

01-Nov-11 8:00 AM

Home

Texting Tracking Utilities Settings

Chk-In Way Pts

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Sem comentários

Beam Shout ts Guia do Utilizador Página 14