Beam Shout ts Guia do Utilizador descarregar pdf (Página 29)

SHOUT ts User’s Manual Version 1.0.1

obtained with the most current ephemeris data being updated and saved. User

can then go back to the Utilities menu to send a test report. When the GPS

receiver cannot acquire a fix, HACC gradually increases and, at some point, stops

at a value of 4294967.500. It is an indicative that the surrounding obstructions

prevent the GPS receiver from obtaining a fix and user should move on to a

different location.

Check Iridium option forces the SHOUT ts to turn on its Iridium transceiver and

continuously update and display signal strength information in real-time. The

Iridium transceiver remains on until user leaves this screen by pressing the back

button. User must be careful not to deplete the battery power by staying on this

option for too long.

When the Test Report option is selected, the SHOUT ts immediately turns the GPS

receiver on to refresh its location data. The location information is continuously

updated and displayed in real-time whether there is a valid fix or not. Similar to

the Check GPS option, HACC can be monitored to see if a valid fix is possible.

Once a valid fix is obtained, the GPS receiver is turned off and the most recent 3-

D fix information is displayed on the screen. This information called test report

can be forced to send to a NOC server by pressing Send. A test report has the

same format as a regular position report and is being treated as such by a NOC.

Sending a test report will not disrupt or change the tracking reporting rate.

Test Report option is a good diagnostic tool used to ensure proper operation of

the GPS receiver and the Iridium transceiver. It can also be used to manage

battery life by turning off tracking mode and strategically send on-demand

location reports. It can be considered as “manual tracking mode”.

Check-In allows user to send a quick message with a single, easy-accessed

button. When the Check-In button is pressed, a second screen will appear

requesting for confirmation. Once confirmed, the SHOUT ts sends out a short code

representing a Check-In message. If Settings/Include GPS option is enabled, GPS

location will be attached to the Check-In message. Check-In messages with GPS

location takes longer to complete since the ts has to acquire a GPS fix first.

Check-In message uses the same canned message’s short code format.

Way Points menu is used to acquire, view, save, delete or send a waypoint to a

NOC. A list of saved waypoints can be displayed and viewed by selecting the List

option. After selecting the List option, any saved waypoint label can be edited,

Chk

Iridium

Test Rpt

Chk-In

Way Points

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Sem comentários

Beam Shout ts Guia do Utilizador Página 29